Ados

Acessórios KM 2000

Hydrocarbon Measurement
Acessórios KM 2000

Sampled gas extraction

Carborundum filter with protective cap,
gas sampling pipe with isolating valve and test gas valve.
Versions:

- V 4 A material (1.4571)
a) with insulation
b) without insulation

a)

b)

Test adapter

- for ITR 498 sensor (PVC)
- for GTR 196 sensor (PVC)
- for ADOS 592 TOX sensor (PVC)
- for GTR 196 and ADOS 592 TOX sensor (aluminium)

Mounting stubs

Mounting stubs with single flange for mounting the gas extraction pipe.
Versions:

- material V4A (1.4571)
- material St 37
- with single flange DN 50 / PN 6, 150 mm long

Explosion vent

Explosion vent for inserts in gas measuring pipes Type Wt,

BAM approved ("BAM" = Federal Institute for Material Testing)

Respirable dust filter with filter cartridge

Double sided cutting ring screw connection for gas pipe breaker R 1/4" or 8 mm cutting ring connection

Condensate collector

Condensate collector with mounting sheet
175 x 260 x 125 mm (WxHxD)

Gasflow schematic

A) Sampled gas suction
B) Mounting stubs with single flange
C) Heated gas suction pipe
1) Sampled gas input
2) Test gas input
3) Pre-filter or balance filter
4) Sampled gas pump
5) Flow regulator
6) Flow-through meter
7) Flow monitor
8) Heating element
9) Catalyser chamber
10) Comparison measurement
11) Measurement point
12) Reaction chamber
13) Measurement amplifier
14) Limit value monitor 1 – 4
15) Measured value integrator
16) Line plotter
17) Concentration indicator
18) Heating element sleeve
19) Temperature controller
20) Resistance thermometer
21) Gas output

Heated extraction pipe

Technical Data:
Length:

1 m – 100 m

Operation temperature: 65 °C … 120 °C
Nominal width: 4 … 8
Nominal voltage: 230 V=
Outer diameter: 42 mm
End caps: with pull relief and bend
protection in PA 6 or silicone
Outer protection: polyamide 6 ring-spendle tube,
flame retardant, halogen-free
Temperatures: -40 °C … +150 °C,
temporary >150 °C
Optional accessory: temperature controller

Test gas bottle

- zero-point-gas: synthetic air
- N-Butane in synthetic air (calibration gas)
- for non-aggressive gases
- for hydrogen sulphide (in stainless steel)
Content: 10 l
Filling pressure: min. 100 bar

Pressure reducer

Pressure reducer for connection to the test gas bottles.
Inlet pressure: max. 200 bar
Output pressure: 0,1 bar – 3 bar
Material: Brass