KM 2000 Accessories Hydrocarbon Measurement Sampled gas extraction Carborundum filter with protective cap, gas sampling pipe with isolating valve and test gas valve. Versions: - V 4 A material (1.4571) a) with insulation b) without insulation a) b) Test adapter - for ITR 498 sensor (PVC) - for GTR 196 sensor (PVC) - for ADOS 592 TOX sensor (PVC) - for GTR 196 and ADOS 592 TOX sensor (aluminium) Mounting stubs Mounting stubs with single flange for mounting the gas extraction pipe. Versions: - material V4A (1.4571) - material St 37 - with single flange DN 50 / PN 6, 150 mm long Explosion vent Explosion vent for inserts in gas measuring pipes Type Wt, BAM approved ("BAM" = Federal Institute for Material Testing) Respirable dust filter with filter cartridge Double sided cutting ring screw connection for gas pipe breaker R 1/4" or 8 mm cutting ring connection Condensate collector Condensate collector with mounting sheet 175 x 260 x 125 mm (WxHxD) Gasflow schematic A) Sampled gas suction B) Mounting stubs with single flange C) Heated gas suction pipe 1) Sampled gas input 2) Test gas input 3) Pre-filter or balance filter 4) Sampled gas pump 5) Flow regulator 6) Flow-through meter 7) Flow monitor 8) Heating element 9) Catalyser chamber 10) Comparison measurement 11) Measurement point 12) Reaction chamber 13) Measurement amplifier 14) Limit value monitor 1 – 4 15) Measured value integrator 16) Line plotter 17) Concentration indicator 18) Heating element sleeve 19) Temperature controller 20) Resistance thermometer 21) Gas output Heated extraction pipe Technical Data: Length: 1 m – 100 m Operation temperature: 65 °C … 120 °C Nominal width: 4 … 8 Nominal voltage: 230 V= Outer diameter: 42 mm End caps: with pull relief and bend protection in PA 6 or silicone Outer protection: polyamide 6 ring-spendle tube, flame retardant, halogen-free Temperatures: -40 °C … +150 °C, temporary >150 °C Optional accessory: temperature controller Test gas bottle - zero-point-gas: synthetic air - N-Butane in synthetic air (calibration gas) - for non-aggressive gases - for hydrogen sulphide (in stainless steel) Content: 10 l Filling pressure: min. 100 bar Pressure reducer Pressure reducer for connection to the test gas bottles. Inlet pressure: max. 200 bar Output pressure: 0,1 bar – 3 bar Material: Brass