KM 2000 Accessoires Hydrocarbon Measurement Sampled gas extraction Carborundum filter with protective cap, gas sampling pipe with isolating valve and test gas valve. Versions: - V 4 A material (1.4571) a) with insulation b) without insulation a) b) Test adapter - for ITR 498 sensor (PVC) - for GTR 196 sensor (PVC) - for ADOS 592 TOX sensor (PVC) - for GTR 196 and ADOS 592 TOX sensor (aluminium) Explosion vent Explosion vent for inserts in gas measuring pipes Type Wt, BAM approved ("BAM" = Federal Institute for Material Testing) Mounting stubs Mounting stubs with single flange for mounting the gas extraction pipe. Versions: - material V4A (1.4571) - material St 37 - with single flange DN 50 / PN 6, 0.49 feet long Condensate collector Condensate collector with mounting sheet 6.89 x 10.24 x 4.92 inch (WxHxD) Respirable dust filter with filter cartridge Double sided cutting ring screw connection for gas pipe breaker R 1/4" or 0.31 inch cutting ring connection. Gasflow schematic A) Sampled gas suction B) Mounting stubs with single flange C) Heated gas suction pipe 1) Sampled gas input 2) Test gas input 3) Pre-filter or balance filter 4) Sampled gas pump 5) Flow regulator 6) Flow-through meter 7) Flow monitor 8) Heating element 9) Catalyser chamber 10) Comparison measurement 11) Measurement point 12) Reaction chamber 13) Measurement amplifier 14) Limit value monitor 1 – 4 15) Measured value integrator 16) Line plotter 17) Concentration indicator 18) Heating element sleeve 19) Temperature controller 20) Resistance thermometer 21) Gas output Heated extraction pipe Technical Data: Length: 3.28 … 328 feet Operation temperature: 149 °F … 248 °F Nominal width: 4 … 8 Nominal voltage: 115 V AC Outer diameter: 1.65 inch End caps: with pull relief and bend protection in PA 6 or silicone Outer protection: polyamide 6 ring-spendle tube, flame retardant, halogen-free Temperatures: -104 °F … +302 °F, temporary >302 °F Optional accessory: temperature controller Test gas bottle - zero-point-gas: synthetic air - N-Butane in synthetic air (calibration gas) - for non-aggressive gases - for hydrogen sulphide (in stainless steel) Content: 2.64 gal Filling pressure: min. 100 bar Pressure reducer Pressure reducer for connection to the test gas bottles. Inlet pressure: max. 200 bar Output pressure: 0,1 bar – 3 bar Material: Brass
