Аксессуары для KM 2000
Аксессуары для систем газосигнализации
Sampled gas extraction
Carborundum filter with protective cap,
gas sampling pipe with isolating valve and test gas valve. |
Versions: |
- V 4 A material (1.4571)
a) with insulation
b) without insulation
|
a)
|
b)
|
|
|
Test adapter
- for ITR 498 sensor (PVC)
- for GTR 196 sensor (PVC)
- for ADOS 592 TOX sensor (PVC)
- for GTR 196 and ADOS 592 TOX sensor (aluminium)
Mounting stubs
Mounting stubs with single flange for mounting the gas extraction pipe. |
Versions: |
- material V4A (1.4571)
- material St 37
- with single flange DN 50 / PN 6, 150 mm long
|
Explosion vent
Explosion vent for inserts in gas measuring pipes Type Wt,
BAM approved ("BAM" = Federal Institute for Material Testing)
Respirable dust filter with filter cartridge
Double sided cutting ring screw connection for gas pipe breaker R 1/4" or 8 mm cutting ring connection
Condensate collector
Condensate collector with mounting sheet
175 x 260 x 125 mm (WxHxD)
Gasflow schematic
A) Sampled gas suction
B) Mounting stubs with single flange
C) Heated gas suction pipe
1) Sampled gas input
2) Test gas input
3) Pre-filter or balance filter
4) Sampled gas pump
5) Flow regulator
6) Flow-through meter
7) Flow monitor
8) Heating element
9) Catalyser chamber
10) Comparison measurement
11) Measurement point
12) Reaction chamber
13) Measurement amplifier
14) Limit value monitor 1 – 4
15) Measured value integrator
16) Line plotter
17) Concentration indicator
18) Heating element sleeve
19) Temperature controller
20) Resistance thermometer
21) Gas output
Heated extraction pipe
Technical Data: |
Length: |
1 m – 100 m
|
Operation temperature: |
65 °C … 120 °C |
Nominal width: |
4 … 8 |
Nominal voltage: |
230 V= |
Outer diameter: |
42 mm |
End caps: |
with pull relief and bend
protection in PA 6 or silicone |
Outer protection: |
polyamide 6 ring-spendle tube,
flame retardant, halogen-free |
Temperatures: |
-40 °C … +150 °C,
temporary >150 °C |
Optional accessory: |
temperature controller |
Test gas bottle
- zero-point-gas: synthetic air
- N-Butane in synthetic air (calibration gas)
- for non-aggressive gases
- for hydrogen sulphide (in stainless steel) |
Content: |
10 l |
Filling pressure: |
min. 100 bar |
Pressure reducer
Pressure reducer for connection to the test gas bottles. |
Inlet pressure: |
max. 200 bar |
Output pressure: |
0,1 bar – 3 bar |
Material: |
Brass |